Transistors By INVENTO

• The HEF4002BP is a positive dual 4-input NOR Gate, the outputs are fully buffered for highest noise immunity and pattern insensitivity of output impedance. The device features standard output capability.
• Logic Family / Base Number: HEF4002; Logic Type: NOR; Output Current: 2.4mA
• No. of Inputs: 4; Supply Voltage: 3V - 15V
• No. of Pins: 14Pins; Logic IC Family: HEF4000; Logic IC Base Number: 4002
• Package Include 4 x 4002 IC

• The IRF540NP from International Rectifier is 100V single N channel HEXFET power MOSFET in TO-220AB package. This MOSFET features extremely low on resistance per silicon area, dynamic dv/dt rating, rugged, fast switching and fully avalanche rated as a result, power MOSFET are well know to provide extremely efficiency and reliability which can be used in wide variety of applications.
• Drain to source voltage Vds is 100V; Gate to source voltage is 20V.
• On resistance Rds(on) of 44mohm at Vgs of 10V; Power dissipation Pd of 130W at 25 degreeC.
• Continuous drain current Id of 33A at Vgs 10V and 25 degreeC; Operating junction temperature range from -55 degreeC to 175 degreeC.
• Package Include 2 x IRF540N

• Collector Emitter Voltage V (br) ceo: 30V; Transition Frequency ft: 300MHz
• Power Dissipation Pd: 500mW; DC Collector Current: 100mA
• DC Current Gain hFE: 110hFE; Transistor Case Style: TO-92
• No. of Pins: 3 Pins; Operating Temperature Max: 150 degreeC
• Package Include: 20 x BC548 Transistor

• The 74LS76 offers individual J, K, Clock Pulse, Direct Set and Direct Clear inputs. These dual flip-flops are designed so that when the clock goes HIGH, the inputs are enabled and data will be accepted.
• The Logic Level of the J and K inputs will perform according to the Truth Table as long as minimum set-up times are observed. Input data is transferred to the outputs on the HIGH-to-LOW clock transitions.
• This device contains two independent positive pulse triggered J-K flip-flops with complementary outputs. The J and K data is processed by the flip-flop after a complete clock pulse. While the clock is low the slave is isolated from the master. On the positive transition of the clock, the data from the J and K inputs is transferred to the master. While the clock is high the J and K inputs are disabled.
• On the negative transition of the clock, the data from the master is transferred to the slave. The logic state of J and K inputs must not be allowed to change while the clock is high. The data is transfered to the outputs on the falling edge of the clock pulse. A low logic level on the preset or clear inputs will set or reset the outputs regardless of the logic levels of the other inputs.
• Package Include 2 x 7476 IC

• The 74HC86N is a quad 2-input exclusive-OR Gate with high-speed Si-gate CMOS devices that comply with JEDEC standard no-7A. The pin is compatible with low-power Schottky TTL (LSTTL ). This provides a 2-input exclusive-OR function.
• Logic Family / Base Number: 74HC86; Logic Type: XOR; Output Current: 5.2mA.
• No. of Inputs: 2; Supply Voltage Min: 2V; Supply Voltage Max: 6V.
• Logic IC Family: 74HC; Logic IC Base Number: 7486.
• Package Include 5 x 7486 IC

• Planar passivated sensitive gate four quadrant triac in a SOT78 (TO-220AB) plastic package intended for use in general purpose bidirectional switching and phase control applications. This sensitive gate \"series E\" triac is intended to be interfaced directly to microcontrollers, logic integrated circuits and other low power gate trigger circuits.
• High blocking voltage capability. Low holding current for low current loads and lowest EMI at commutation
• Planar passivated for voltage ruggedness and reliability.Triggering in all four quadrants
• Direct triggering from low power drivers and logic ICs. Sensitive gate
• Package Include: 3 x BT136-600E

• The 74HCT74D is a dual positive edge triggered D-type Flip-flop has individual data (nD), clock (nCP), set (nSD) and reset (nRD) inputs and complementary nQ and nQ outputs. Data at the nD-input, that meets the set-up and hold time requirements on the low-to-high clock transition, is stored in the flip-flop and appears at the nQ output.
• Schmitt-trigger action in the clock input, makes the circuit highly tolerant to slower clock rise and fall times. Inputs include clamp diodes that enable the use of current limiting resistors to interface inputs to voltages in excess of VCC.
• Logic Family / Base Number: 74HCT74; Flip-Flop Type: D; Propagation Delay: 15ns; Frequency: 59MHz; Output Current: 4mA; Logic Case Style: SOIC; No. of Pins: 14Pins
• Trigger Type: Positive Edge; IC Output Type: Complementary; Supply Voltage Min: 4.5V; Supply Voltage Max: 5.5V; Logic IC Family: 74HCT; Logic IC Base Number: 7474
• Package Include 2 x 7474 IC

• The BD139 from STMicroelectronics is a through hole NPN complementary low voltage transistor in TO-126 (SOT-32) package. This device manufactured in epitaxial planar technology. Used for audio amplifiers and drivers, utilizing complementary or quasi complementary circuits.
• Collector to emitter voltage (Vce) is 80V. Collector current (Ic) is 1.5A
• Power dissipation (Pd) is 12.5W. Collector to emitter saturation voltage of 500mV at 0.5A collector current.
• DC current gain (hFE) of 25 at 0.5A collector current. Operating junction temperature range from 150 degreeC.
• Package Include: 5 x BD139

• The SN74LS32N is a quad 2-input Positive-OR Gate characterized for operation from 0 to 70 degreeC.
• Logic Family / Base Number: 74LS32; Logic Type: OR; Output Current: 8mA.
• No. of Inputs: 2; Supply Voltage Min: 4.75V; Supply Voltage Max: 5.25V.
• Logic IC Family: 74LS; Logic IC Base Number: 7432; Product Range: OR Gate.
• Package Include 5 x 7432 IC

• These devices contain three independent 3-input NAND gates with open-collector outputs.
• The open-collector outputs require pull-up resistor to perform correctly.
• They may be connected to other open-collector outputs to implement active-low wired-OR or active -high wired-AND functions. Open-Collector devices are often used to generate higher VOH levels.
• The SN5412 and SN54LS12 are characterized for operation over the full military range of -55 degree celcius to 125 degree celcius. The SN7412 and SN74LS12 are characterized for operation from 0 degree celcius to 70 degree celcius.
• Package Include 4 x 7412 IC

• The 74HCT85D is a 4-bit CMOS Magnitude Comparator pin compatible with low power Schottky TTL (LSTTL). It can be expanded to almost any length. It performs the comparison of two 4-bit binary, BCD or other monotonic codes and present the three possible magnitude results at the outputs. The 4-bit inputs are weighted, where A3 and B3 are the most significant bits.
• The upper part of the table describes the normal operation under all conditions that will occur in a single device or in a series expansion scheme. In the upper part of the table the three outputs are mutually exclusive. In the lower part of the table, the outputs reflect the feed forward conditions that exist in the parallel expansion scheme.
• Logic Family / Base Number: 74HCT85; Comparator Type: Magnitude; No. of Channels: 4Channels; No. of Bits: 4bit.
• No. of Pins: 16Pins; Supply Voltage Min: 4.5V; Supply Voltage Max: 5.5V; Logic IC Base Number: 7485.
• Package Include 2 x 7485 IC

• Medium Power Transistor Suitable for a wide Range of Medium Voltage and Current Amplifier Applications.
• Collector to emitter voltage (Vce) is 50V. Collector current (Ic) is 1A
• Power dissipation (Pd) is 0.8W. Collector emitter saturation voltage of 50V at Ic=10mA.
• Operating junction temperature range from -55 degreeC to 150 degreeC
• Package Include: 3 x CK100B Transistor

• The LM3914N-1 is a monolithic integrated circuit that senses analogue voltage levels and drives 10 LEDs, providing a linear analogue display. Current drive to the LEDs is regulated and programmable, eliminating the need for resistors.
• Drives LEDs, LCDs or vacuum fluorescents; Bar or dot display mode externally selectable by user; Expandable to displays of 100 steps; Inputs operate down to ground.
• No multiplexing switching or interaction between outputs; LED driver outputs are current regulated, open-collectors; Outputs can interface with TTL or CMOS logic.
• Applications: LED Lighting, Lighting
• Package Include 2 x LM3914N

• The CD4050BE is a CMOS Hex non-inverting Buffer/Converter feature logic-level conversion using only one supply voltage (VCC). The input-signal high level (VIH) can exceed the VCC supply voltage when these devices are used for logic-level conversions. These devices are intended for use as CMOS to DTL/TTL converters and can drive directly two DTL/TTL loads.
• High sink current for driving 2 TTL loads; High-to-low level logic conversion; Maximum input current of 1?A at 18V.
• Logic Device Type: Buffer, Non Inverting; Logic Family / Base Number: CD4050; No. of Pins: 16Pins.
• Supply Voltage: 3V - 18V; Logic IC Base Number: 4050
• Package Include 2 x 4050 IC

• The 74HC4017N is a Johnson decade Counter with 10 decoded outputs (Q0 to Q9), an output from the most significant flip-flop (Q5-9), two clock inputs (CP0 and CP1) and an overriding asynchronous master reset input (MR). The counter is advanced by either a low-to-HIGH transition at CP0 while CP1 is low or a high-to-low transition at CP1 while CP0 is high.
• When cascading counters, the Q5-9 output, which is low while the counter is in states 5, 6, 7, 8 and 9, can be used to drive the CP0 input of the next counter. A high on MR resets the counter to zero independent of the clock inputs.
• Automatic code correction of the counter is provided by an internal circuit following any illegal code the counter returns to a proper counting mode within 11 clock pulses. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.
• Logic Family / Base Number: 74HC4017; Counter Type: Decade; Clock Frequency: 83MHz; Count Maximum: 5; No. of Pins: 16Pins; Supply Voltage: 2V - 6V; Logic IC Base Number: 744017
• Package Include: 4 x 744017 IC

• Collector-base voltage: 60V
• Collector-emitter voltage: 40V; Emitter-base voltage: 6V
• Transition frequency: 100MHz
• Collector current: 0.2A; Power dissipation: 625mW
• Package Include: 10 x 2N3904