Hydraulic & Pneumatic Equipment By Legines

• Union pipe fitting for joining two pipes.
• 3/8\" Female NPT threads for connecting to 3/8\" male threaded pipes
• Legines pipe fittings are made of CA360 or CA377 brass, not ordinary copper alloy, and meet SAE standard, have dryseal threads, forgings & extruded.
• These fittings contain lead and are not allowed by federal law to be installed for potable water use in the U.S.A. and its territories.
• Operating pressure of our fittings is up to 1200psi, more higher than other general fittings. Temperatures range from -53 to 121 degrees C (-65 to 250 degrees F)

• Tube nut for use with inverted flared tubing
• Brass for corrosion resistance, ductility at high temperatures, and low magnetic permeability
• For use with liquid petroleum (LP) and natural gas, refrigeration, hydraulic brake, trans-mission cooler lines, fuel, oil, air, lines, power steering.
• Not for use in potable drinking water applications
• Working pressure up to 2000psi depending on Tube (O.D),Will withstand burst pressure 5000psi with bundy-weld.

• Flare cap for terminating/closing pipe end
• It is important to use flare fittings when you are dealing with a lot of water pressure going through a pipe or are dealing with high gas distribution.
• Flare fittings on the end of copper tubing should provide a strong connection to a fixed point with a threaded nipple.
• Used for fuel, oil, air, propane, liquid petroleum (LP) and natural gas lines connections
• These fittings contain lead and are not allowed by federal law to be installed for potable water use in the U.S.A. and its territories.

• Adapts 1/8\" NPT female end to 5/16\" tube size female end
• Brass for corrosion resistance, ductility at high temperatures, and low magnetic permeability
• For use with liquid petroleum (LP) and natural gas, refrigeration, hydraulic brake, trans-mission cooler lines, fuel, oil, air, lines, power steering.
• Not for use in potable drinking water applications.
• Working pressure up to 2000psi depending on Tube (O.D),Will withstand burst pressure 5000psi with bundy-weld.

• Long nipple for connecting two threaded pipes and extending pipe length
• 3/8\" Male National Pipe Taper (NPT) threads for connecting to 3/8\" female threaded pipes
• Brass for higher corrosion resistance, ductility at high temperatures, and low magnetic permeability
• Operating temperatures range from -53 to 121 degrees C (-65 to 250 degrees F)
• These fittings contain lead and are not allowed by federal law to be installed for potable water use in the U.S.A. and its territories.